Wavlink AC1200 Extender for Manual Setup Instructions-User Manual

It is possible to configure your Wavlink AC1200 extender in a way that will offer the best possible performance in conjunction with your router by means of this method. Before beginning, you should confirm that your wireless router supports WPS. Please follow the instructions below carefully in order to find lateral information. 

First, plug the power cable of the Wavlink extender into an electric outlet. After that, the indicator LED of the Wavlink extender device will turn steady and then will begin to blink fast. Next, press and hold the WPS button on the back of the router for six seconds to continue with the Wavlink AC1200 setup. After that, you will have to wait for two minutes, then press the WPS button inside the Wavlink extender. After that, the WPS LED on both devices will start to blink in solid blue. This means the connection between the extender and router would have been successfully established after both WPS buttons were pressed. 

In case the WPS LED is not glowing steadily, it implies that your router and extender are not near each other. So please rectify this by placing the extender in proper range. This will correct the issue.